How to Build a Car Body Rotator

Materials

• 1/2-inch plywood
• 2x4s
• 4x4s
• 1/2-inch bolts
• Nuts and washers
• Drill
• Saw
• Wrench

Instructions

1. Cut two pieces of 1/2-inch plywood to the desired size of the rotator. These will be the top and bottom of the rotator.
2. Cut four pieces of 2×4 to the length of the desired width of the rotator. These will be the sides of the rotator.
3. Cut four pieces of 4×4 to the length of the desired height of the rotator. These will be the legs of the rotator.
4. Assemble the sides and legs of the rotator using 1/2-inch bolts, nuts, and washers.
5. Attach the top and bottom of the rotator to the sides using 1/2-inch bolts, nuts, and washers.
6. Drill a hole in the center of the top of the rotator. This hole will be used to attach the car to the rotator.
7. Attach the car to the rotator using a bolt, nut, and washer.

Tips

• Use treated lumber for the rotator if it will be used outdoors.
• Make sure the rotator is level before attaching the car.
• Use a large enough bolt to attach the car to the rotator.
• Be careful when operating the rotator.

Conclusion

Building a car body rotator is a relatively simple project that can be completed in a few hours. This tool can be used to make it easier to work on your car, and it can also be used to display your car at shows.