How to Mount a Hard Plastic Body on an RC Car

Mounting a hard plastic body on an RC car is a relatively simple process, but there are a few things you need to keep in mind in order to ensure a secure and durable fit.

Materials You’ll Need

• Hard plastic body
• Body mounts
• Body clips
• Screwdriver
• Drill (optional)

Step 1: Prepare the Body

1. Start by cleaning the inside of the body with a mild detergent and water. This will remove any dirt or debris that could interfere with the mounting process.
2. Once the body is clean, dry it thoroughly with a clean towel.
3. Next, mark the locations of the body mounts on the inside of the body. You can use a pencil or a marker for this.
4. If the body does not come with pre-drilled holes for the body mounts, you will need to drill them yourself. Use a drill bit that is the same size as the screws that will be used to secure the body mounts.

Step 2: Install the Body Mounts

1. Position the body mounts on the inside of the body, aligning them with the marks you made in the previous step.
2. Secure the body mounts with screws.
3. Repeat this process for all of the body mounts.

Step 3: Mount the Body

1. Place the body on the chassis of the RC car, aligning the body mounts with the corresponding holes in the chassis.
2. Secure the body with body clips. Start by inserting the clips into the holes in the body mounts, then push the clips down until they snap into place.
3. Repeat this process for all of the body clips.

Step 4: Check the Fit

1. Once the body is mounted, check the fit by gently pushing and pulling on it. The body should be secure and should not move around excessively.
2. If the body is not secure, tighten the body clips or adjust the position of the body mounts.

Tips

• Use a body reamer to enlarge the holes in the body for the body mounts. This will make it easier to install the body mounts and will help to prevent the body from cracking.
• Use a locking compound on the screws that secure the body mounts. This will help to prevent the screws from loosening over time.
• If you are mounting a painted body, be sure to protect the paint from scratches by using a clear coat or a body protector.

Conclusion

Mounting a hard plastic body on an RC car is a simple process that can be completed in a matter of minutes. By following these steps, you can ensure a secure and durable fit for your body.