Install Remote Car Starter Manual Transmission
Introduction
A remote car starter is a great way to make your life easier, especially during the winter months. With a remote car starter, you can start your car from the comfort of your home or office, so you don’t have to sit in the cold and wait for it to warm up. Installing a remote car starter on a manual transmission can be a bit more challenging than installing one on an automatic transmission, but it’s still possible to do it yourself with a little patience and some basic tools.
What You’ll Need
Before you begin, you’ll need to gather the following tools and materials:
* Remote car starter kit
* Wire strippers and crimpers
* Electrical tape
* Zip ties
* Drill and drill bits
* Socket wrench set
* Screwdriver set
* Multimeter
Step 1: Prepare the Car
Before you start installing the remote car starter, you need to prepare the car. This involves disconnecting the battery and removing the lower dash panel.
To disconnect the battery, use a wrench to loosen the negative battery terminal. Once the terminal is loose, pull it off the battery and set it aside.
To remove the lower dash panel, use a screwdriver to remove the screws that hold it in place. Once the screws are removed, pull the panel off and set it aside.
Step 2: Install the Control Module
The control module is the brains of the remote car starter. It’s responsible for receiving the signal from the remote and sending the appropriate commands to the car’s electrical system.
To install the control module, find a suitable location under the dash. The location should be close to the ignition switch and the wiring harness. Once you’ve found a location, use the screws that came with the kit to mount the control module in place.
Step 3: Wire the Control Module
Once the control module is installed, you need to wire it to the car’s electrical system. The wiring diagram that came with the kit will show you how to do this.
To wire the control module, you’ll need to use wire strippers and crimpers to connect the wires to the appropriate terminals on the control module and the car’s wiring harness. Once the wires are connected, use electrical tape to insulate the connections.
Step 4: Install the Antenna
The antenna is responsible for receiving the signal from the remote. It should be installed in a location where it has a clear view of the sky.
To install the antenna, find a suitable location on the windshield. Clean the area with rubbing alcohol and then peel off the backing of the adhesive tape on the antenna. Press the antenna onto the windshield and hold it in place for a few seconds.
Step 5: Install the Remote
The remote is used to send the signal to the control module. It can be attached to your keychain or kept in your pocket.
To install the remote, follow the instructions that came with the kit.
Step 6: Test the Remote Car Starter
Once the remote car starter is installed, you need to test it to make sure it’s working properly.
To test the remote car starter, stand away from the car and press the start button on the remote. The car should start within a few seconds. If the car doesn’t start, check the wiring connections and make sure that the control module is getting power.
Conclusion
Installing a remote car starter on a manual transmission can be a bit of a challenge, but it’s definitely possible to do it yourself with a little patience and some basic tools. By following the steps in this guide, you can install a remote car starter on your manual transmission car and enjoy the convenience of starting your car from the comfort of your home or office.
