Repair Lexan RC Car Body Where Clips Go

Introduction

Lexan is a lightweight, durable plastic that is often used to make RC car bodies. However, Lexan can be damaged, especially if it is hit by another car or object. If the damage is in an area where a clip is located, it can be difficult to repair.

Materials Needed

To repair a Lexan RC car body where a clip goes, you will need the following materials:

* Lexan repair tape
* Scissors
* A heat gun or hair dryer
* A credit card or other flat object
* A clean cloth

Instructions

1. Clean the area around the damaged clip with a clean cloth.
2. Cut a piece of Lexan repair tape that is slightly larger than the damaged area.
3. Peel off the backing of the Lexan repair tape and apply it to the damaged area.
4. Use a heat gun or hair dryer to heat the Lexan repair tape until it is soft and pliable.
5. Use a credit card or other flat object to press down on the Lexan repair tape and smooth it out.
6. Allow the Lexan repair tape to cool completely.

Tips

* If the damaged area is large, you may need to use multiple pieces of Lexan repair tape.
* Be careful not to overheat the Lexan repair tape, as this can cause it to melt.
* If you are not sure how to use a heat gun or hair dryer, ask a friend or family member for help.

Conclusion

Repairing a Lexan RC car body where a clip goes is a relatively easy process. By following the instructions in this article, you can quickly and easily repair your RC car body and get it back on the track.