94 Town Car Automatic Transmission MLPS Switch Located
What is the MLPS switch?
The MLPS (Manual Lever Position Switch) switch is a component of the automatic transmission in a 94 Town Car. It is responsible for sending a signal to the transmission control module (TCM) to indicate the position of the gear selector lever. This information is used by the TCM to determine which gear should be engaged.
Where is the MLPS switch located?
The MLPS switch is located on the side of the transmission, near the gear selector lever. It is held in place by two bolts.
How to replace the MLPS switch
To replace the MLPS switch, you will need the following tools:
* 10mm socket wrench
* 13mm socket wrench
* Flathead screwdriver
1. Disconnect the negative battery terminal.
2. Raise the vehicle on a jackstand.
3. Remove the two bolts that hold the MLPS switch in place.
4. Disconnect the electrical connector from the MLPS switch.
5. Remove the MLPS switch from the transmission.
6. Install the new MLPS switch in the transmission.
7. Connect the electrical connector to the MLPS switch.
8. Tighten the two bolts that hold the MLPS switch in place.
9. Lower the vehicle to the ground.
10. Reconnect the negative battery terminal.
Symptoms of a bad MLPS switch
A bad MLPS switch can cause a number of problems, including:
* Difficulty shifting gears
* Transmission slipping out of gear
* Check engine light coming on
* Transmission control module (TCM) going into limp mode
If you experience any of these symptoms, it is important to have your MLPS switch checked by a qualified mechanic.
Conclusion
The MLPS switch is an important component of the automatic transmission in a 94 Town Car. It is responsible for sending a signal to the TCM to indicate the position of the gear selector lever. If the MLPS switch fails, it can cause a number of problems. If you experience any of the symptoms of a bad MLPS switch, it is important to have your switch checked by a qualified mechanic.
