Car Mechanic Simulator 2018 Transmission Not Responsive

If you’re experiencing issues with your transmission not responding in Car Mechanic Simulator 2018, there are a few things you can try to fix the problem.

Check the transmission fluid level

The first thing you should do is check the transmission fluid level. If the fluid level is low, it can cause the transmission to slip and not engage properly. To check the fluid level, follow these steps:

1. Park the car on a level surface and turn off the engine.
2. Locate the transmission fluid dipstick. It is usually located near the back of the engine, next to the firewall.
3. Pull out the dipstick and wipe it clean with a rag.
4. Reinsert the dipstick into the transmission and pull it out again.
5. Check the fluid level on the dipstick. It should be between the “min” and “max” marks.

If the fluid level is low, add more fluid until it reaches the correct level. Be sure to use the type of fluid that is recommended for your car’s transmission.

Inspect the transmission filter

The transmission filter can become clogged over time, which can restrict the flow of fluid and cause the transmission to slip. To inspect the transmission filter, follow these steps:

1. Park the car on a level surface and turn off the engine.
2. Locate the transmission filter. It is usually located on the side of the transmission, near the bottom.
3. Remove the transmission filter bolts and pull out the filter.
4. Inspect the filter for any debris or blockages. If the filter is clogged, replace it with a new one.
5. Reinstall the transmission filter and tighten the bolts.

Check the transmission solenoid

The transmission solenoid is a electrical component that controls the flow of fluid in the transmission. If the solenoid is faulty, it can cause the transmission to slip or not engage properly. To check the transmission solenoid, follow these steps:

1. Park the car on a level surface and turn off the engine.
2. Locate the transmission solenoid. It is usually located on the side of the transmission, near the top.
3. Disconnect the electrical connector from the solenoid.
4. Use a multimeter to test the solenoid for continuity. If the solenoid is not working, replace it with a new one.
5. Reconnect the electrical connector to the solenoid.

Inspect the transmission bands

The transmission bands are metal bands that help to engage the gears in the transmission. If the bands are worn or damaged, it can cause the transmission to slip or not engage properly. To inspect the transmission bands, follow these steps:

1. Park the car on a level surface and turn off the engine.
2. Remove the transmission pan.
3. Inspect the transmission bands for any wear or damage. If the bands are worn or damaged, replace them with new ones.
4. Reinstall the transmission pan.

If you have tried all of the above and the transmission is still not responding, you may need to take your car to a mechanic for further diagnosis and repair.