Eric the Car Guy 2002 Honda Odyssey Transmission Cooler Flush

In this video, Eric the Car Guy shows you how to flush the transmission cooler on a 2002 Honda Odyssey. This is a relatively simple procedure that can help to extend the life of your transmission.

Tools and materials needed

10mm socket wrench
14mm socket wrench
17mm socket wrench
Drain pan
New transmission cooler
Transmission fluid

Step-by-step instructions

Start by disconnecting the negative battery terminal.
Locate the transmission cooler. It is located in front of the radiator.
Place a drain pan under the transmission cooler.
Use a 10mm socket wrench to remove the two bolts that hold the transmission cooler in place.
Carefully remove the transmission cooler. Be careful not to spill any fluid.
Use a 14mm socket wrench to remove the two bolts that hold the transmission cooler lines in place.
Carefully remove the transmission cooler lines.
Install the new transmission cooler.
Tighten the bolts that hold the transmission cooler in place.
Install the transmission cooler lines.
Tighten the bolts that hold the transmission cooler lines in place.
Reconnect the negative battery terminal.
Start the engine and check for leaks.
Add transmission fluid to the transmission until the level is correct.

Tips

It is important to use the correct type of transmission fluid for your vehicle.
Be careful not to overtighten the bolts.
If you are not comfortable performing this procedure, you can have it done by a mechanic.

Conclusion

Flushing the transmission cooler is a relatively simple procedure that can help to extend the life of your transmission. By following the steps outlined in this video, you can easily complete this task yourself.