Remote Car Starter Installation Manual Transmission

Introduction

A remote car starter is a great way to make your life easier, especially during the cold winter months. With a remote car starter, you can start your car from anywhere within range, so you can warm it up before you even get inside. This is especially convenient if you have to park your car outside overnight.

Installing a remote car starter in a manual transmission vehicle is a bit more complicated than installing one in an automatic transmission vehicle. However, it is still possible to do it yourself with the right tools and instructions.

Tools and Materials

• Remote car starter kit
• Crimping tool
• Electrical tape
• Wire strippers
• Drill
• 1/2-inch drill bit
• 3/8-inch drill bit
• 1/4-inch drill bit
• Socket wrench set
• Phillips head screwdriver
• Flat head screwdriver
• Zip ties

Instructions

1. Disconnect the battery. This is a safety precaution that will prevent you from getting shocked. To disconnect the battery, simply loosen the negative terminal with a wrench and remove it from the battery post.
2. Locate the wiring harness. The wiring harness is a bundle of wires that runs from the fuse box to the ignition switch. It is usually located under the dashboard, near the steering column. Once you have located the wiring harness, identify the following wires:
• White wire: This is the ignition wire.
• Yellow wire: This is the starter wire.
• Black wire: This is the ground wire.
3. Connect the remote car starter wires to the wiring harness. To do this, use the crimp tool to crimp the connectors on the remote car starter wires to the corresponding wires on the wiring harness. Make sure that the connections are secure and that there are no loose wires.
4. Install the remote car starter module. The remote car starter module is the brain of the system. It is usually mounted under the dashboard, near the steering column. Once you have found a suitable location, use the screws that came with the remote car starter kit to secure the module in place.
5. Connect the antenna. The antenna is used to receive the signal from the remote control. It is usually mounted on the windshield, near the top of the vehicle. Once you have found a suitable location, use the screws that came with the remote car starter kit to secure the antenna in place.
6. Reconnect the battery. Once all of the connections have been made, reconnect the battery. To do this, simply tighten the negative terminal back onto the battery post.
7. Program the remote control. The remote control is programmed to communicate with the remote car starter module. To program the remote control, follow the instructions that came with the remote car starter kit.

Troubleshooting

If you are having trouble installing your remote car starter, there are a few things that you can check:

• Make sure that all of the connections are secure. Loose connections can cause the remote car starter to malfunction.
• Check the fuses. If a fuse has blown, the remote car starter will not work. Replace any blown fuses with new ones of the same amperage.
• Contact the manufacturer. If you are still having trouble installing your remote car starter, you can contact the manufacturer for help.

Conclusion

Installing a remote car starter in a manual transmission vehicle is a bit more complicated than installing one in an automatic transmission vehicle. However, it is still possible to do it yourself with the right tools and instructions. By following the steps outlined in this article, you can install a remote car starter in your manual transmission vehicle and enjoy the convenience of starting your car from anywhere.