Retrofit Gas Car to Electric Automatic Transmission

Introduction

Electric vehicles (EVs) are becoming increasingly popular due to their many benefits, including reduced emissions, lower operating costs, and improved performance. However, the high cost of new EVs can be a barrier to entry for many consumers.

One way to reduce the cost of EV ownership is to retrofit a gas-powered car to electric. This can be a complex and expensive process, but it can also be a rewarding one. By following the steps outlined in this guide, you can retrofit your gas car to electric automatic transmission.

Step 1: Gather your materials

The first step in retrofitting your gas car to electric is to gather your materials. You will need the following items:

• An electric motor and controller
• A battery pack
• A charging system
• A wiring harness
• Tools

Step 2: Remove the gas engine and transmission

Once you have gathered your materials, you can begin the process of removing the gas engine and transmission. This is a complex process, so it is important to follow the instructions carefully.

To remove the gas engine, you will need to disconnect the following items:

• The fuel line
• The exhaust system
• The coolant lines
• The electrical connections

Once the gas engine is disconnected, you can remove it from the car. To remove the transmission, you will need to disconnect the following items:

• The driveshaft
• The shifter linkage
• The electrical connections

Once the transmission is disconnected, you can remove it from the car.

Step 3: Install the electric motor and controller

Once the gas engine and transmission have been removed, you can install the electric motor and controller. The electric motor will be mounted in the same location as the gas engine, and the controller will be mounted in a convenient location.

To install the electric motor, you will need to connect the following items:

• The power wires
• The ground wire
• The motor controller

To install the controller, you will need to connect the following items:

• The power wires
• The ground wire
• The motor
• The battery pack
• The charging system

Step 4: Install the battery pack

The battery pack is the heart of the electric vehicle. It provides the power to the electric motor. The battery pack will be mounted in the trunk or under the hood of the car.

To install the battery pack, you will need to connect the following items:

• The positive terminal to the positive terminal on the controller
• The negative terminal to the negative terminal on the controller
• The ground wire to the chassis of the car

Step 5: Install the charging system

The charging system will allow you to charge the battery pack. The charging system will be mounted in the trunk or under the hood of the car.

To install the charging system, you will need to connect the following items:

• The power wires to the battery pack
• The ground wire to the chassis of the car
• The charging port to the outside of the car

Step 6: Install the wiring harness

The wiring harness will connect all of the components of the electric vehicle. The wiring harness will be routed through the car, and it will be connected to the following items:

• The electric motor
• The controller
• The battery pack
• The charging system
• The shifter
• The gauges

Step 7: Test the electric vehicle

Once the wiring harness is installed, you can test the electric vehicle. To test the electric vehicle, you will need to do the following:

• Turn on the key
• Shift the car into drive
• Press the accelerator

The electric vehicle should start moving forward. If the electric vehicle does not move forward, you will need to check the following:

• The power wires
• The ground wire
• The motor controller
• The battery pack
• The charging system

Conclusion

Retrofitting a gas car to electric automatic transmission is a complex and expensive process, but it can also be a rewarding one. By following the steps outlined in this guide, you can retrofit your gas car to electric and enjoy the many benefits of EV ownership.