06 Lincoln Town Car Transmission Band Adjustment

Tools Required

10mm socket
13mm socket
15mm socket
18mm socket
Torque wrench
Flathead screwdriver
Transmission fluid
Funnel

Safety Precautions

Park the vehicle on a level surface and engage the parking brake.
Allow the engine to cool down before beginning work.
Wear safety glasses and gloves.
Do not smoke or work near open flames.

Procedure

Disconnect the negative battery terminal.
Raise the vehicle and support it on jack stands.
Remove the transmission pan bolts and lower the pan.
Inspect the transmission fluid for any signs of contamination or debris.
If the fluid is contaminated or debris is present, replace the fluid and filter.
Locate the transmission band adjuster bolt on the driver’s side of the transmission.
Use a 10mm socket to loosen the locknut on the adjuster bolt.
Use a 13mm socket to turn the adjuster bolt clockwise to tighten the band.
Tighten the adjuster bolt until the band is snug, but not too tight.
Reinstall the locknut and tighten it to 18 ft-lbs.
Reinstall the transmission pan and tighten the bolts to 10 ft-lbs.
Lower the vehicle and reconnect the negative battery terminal.
Start the engine and check for leaks.
Drive the vehicle for a few miles and check for any transmission problems.

Tips

If you are not comfortable performing this adjustment yourself, it is recommended that you take your vehicle to a qualified mechanic.
It is important to check the transmission fluid level after making any adjustments.
Over-tightening the transmission band can cause damage to the transmission.

Conclusion

Adjusting the transmission band on a 06 Lincoln Town Car is a relatively simple procedure that can be performed at home with basic tools. By following the steps outlined in this guide, you can ensure that your transmission is operating properly.