Contents
- 2000 Lincoln Town Car Transmission Fluid Change
- Tools and Materials Needed
- Safety Precautions
- Step-by-Step Instructions
- 1. Remove the transmission fluid pan
- 2. Replace the transmission filter
- 3. Replace the transmission fluid pan gasket
- 4. Reinstall the transmission fluid pan
- 5. Add new transmission fluid
- 6. Check for leaks
- 7. Reset the transmission fluid life monitor
- Tips
- Conclusion
2000 Lincoln Town Car Transmission Fluid Change
Tools and Materials Needed
- New transmission fluid (Ford Mercon V or equivalent)
- New transmission filter
- Transmission fluid pan gasket
- 3/8-inch ratchet
- 10mm socket
- 13mm socket
- 15mm socket
- 17mm socket
- Drain pan
- Funnel
- Rags
Safety Precautions
- Park the vehicle on a level surface and engage the parking brake.
- Allow the engine to cool completely before beginning work.
- Wear gloves and eye protection when handling transmission fluid.
Step-by-Step Instructions
1. Remove the transmission fluid pan
- Locate the transmission fluid pan at the bottom of the transmission.
- Use a 10mm socket to remove the bolts that hold the pan in place.
- Carefully lower the pan and allow the transmission fluid to drain into the drain pan.
2. Replace the transmission filter
- Locate the transmission filter inside the pan.
- Use a 13mm socket to remove the bolts that hold the filter in place.
- Remove the old filter and replace it with the new filter.
- Tighten the bolts to 12 foot-pounds.
3. Replace the transmission fluid pan gasket
- Remove the old transmission fluid pan gasket.
- Clean the gasket surface on the pan and the transmission.
- Apply a thin bead of RTV sealant to the gasket surface on the pan.
- Install the new gasket on the pan.
4. Reinstall the transmission fluid pan
- Lift the transmission fluid pan into place.
- Use a 10mm socket to tighten the bolts that hold the pan in place.
- Tighten the bolts to 12 foot-pounds.
5. Add new transmission fluid
- Use a funnel to add new transmission fluid to the transmission.
- Add fluid until it reaches the “full” mark on the dipstick.
6. Check for leaks
- Start the engine and let it idle for a few minutes.
- Check for any leaks from the transmission fluid pan.
7. Reset the transmission fluid life monitor
- Turn the ignition key to the “on” position, but do not start the engine.
- Press and hold the accelerator pedal for 10 seconds.
- Release the accelerator pedal and turn the ignition key to the “off” position.
Tips
- It is recommended to change the transmission fluid every 30,000 to 60,000 miles.
- If the transmission fluid is dark or smells burnt, it may need to be changed more often.
- If you are not comfortable performing this procedure yourself, you can have it done by a mechanic.
Conclusion
Changing the transmission fluid in a 2000 Lincoln Town Car is a relatively simple procedure that can be completed in about an hour. By following these instructions, you can save money and keep your transmission running smoothly.