2006 Lincoln Town Car Transmission Fluid Capacity

Introduction

The 2006 Lincoln Town Car is a full-size luxury sedan that was produced by Ford Motor Company. It was the last year of production for the Town Car, which had been in production since 1981. The Town Car was available with a variety of engine and transmission options, including a 4.6-liter V8 engine and a 4-speed automatic transmission.

The transmission fluid capacity for the 2006 Lincoln Town Car with the 4-speed automatic transmission is 5.8 quarts. It is important to check the transmission fluid level regularly and to change the fluid and filter according to the manufacturer’s recommended maintenance schedule.

Checking the Transmission Fluid Level

To check the transmission fluid level, follow these steps:

1. Park the vehicle on a level surface.
2. Shift the transmission into park.
3. Open the hood and locate the transmission fluid dipstick.
4. Pull out the dipstick and wipe it clean with a rag.
5. Reinsert the dipstick into the transmission fluid dipstick tube.
6. Pull out the dipstick again and check the fluid level.

The transmission fluid level should be between the “full” and “add” marks on the dipstick. If the fluid level is low, add fluid through the dipstick tube until the level is correct.

Changing the Transmission Fluid and Filter

The transmission fluid and filter should be changed according to the manufacturer’s recommended maintenance schedule. The following steps will guide you through the process of changing the transmission fluid and filter:

1. Gather the necessary materials, including:
* New transmission fluid (5.8 quarts)
* New transmission filter
* Transmission pan gasket
* Drain pan
* Rags
2. Park the vehicle on a level surface and allow the engine to cool.
3. Shift the transmission into park.
4. Open the hood and locate the transmission fluid drain plug.
5. Place the drain pan under the transmission fluid drain plug.
6. Loosen the drain plug and allow the fluid to drain into the pan.
7. Once the fluid has stopped draining, replace the drain plug and tighten it to the specified torque.
8. Remove the transmission pan bolts and carefully remove the pan.
9. Remove the old transmission filter and replace it with the new filter.
10. Clean the transmission pan mating surfaces and install the new transmission pan gasket.
11. Install the transmission pan and tighten the bolts to the specified torque.
12. Add the new transmission fluid through the dipstick tube.
13. Start the engine and allow it to idle for a few minutes.
14. Shift the transmission through all of the gears and then check the fluid level.
15. Add fluid if necessary and then check for leaks.

Conclusion

Changing the transmission fluid and filter is an important part of maintaining your 2006 Lincoln Town Car. By following the steps outlined in this article, you can ensure that your transmission is operating properly and that you are getting the most out of your vehicle.