Best Way to Pump Transmission Fluid Out of Car

If you’re looking to change the transmission fluid in your car, you’ll need to know how to pump the old fluid out. There are a few different ways to do this, but the most common method is to use a hand pump.

Here’s a step-by-step guide on how to pump transmission fluid out of your car:

Materials You’ll Need

• Hand pump
• Transmission fluid
• Funnel
• Rags or paper towels
• Bucket or drain pan

Step-by-Step Instructions

1. Safety First

Before you start, make sure your car is parked on a level surface and that the parking brake is engaged. Allow the engine to cool down completely before you begin. Transmission fluid can be hot and cause burns if it comes into contact with your skin.

2. Locate the Transmission Fluid Dipstick

Open the hood of your car and locate the transmission fluid dipstick. It’s usually a bright red or yellow dipstick with a loop at the end. Pull out the dipstick and wipe it clean with a rag or paper towel.

3. Insert the Hand Pump into the Transmission Fluid Dipstick Tube

Insert the hand pump into the transmission fluid dipstick tube. Make sure the pump is inserted all the way to the bottom of the tube. If the pump is not inserted far enough, it will not be able to pump out all of the old fluid.

4. Start Pumping

Begin pumping the transmission fluid out of the dipstick tube. Pump until the fluid level on the dipstick reaches the “Full” mark. Once the fluid level reaches the “Full” mark, stop pumping.

5. Add New Transmission Fluid

Use a funnel to add new transmission fluid to the dipstick tube. Add fluid until the level reaches the “Full” mark on the dipstick.

6. Check for Leaks

Start the engine and let it run for a few minutes. Check for leaks around the transmission fluid dipstick tube and the transmission pan. If you see any leaks, tighten the bolts or replace the gasket.

7. Reset the Transmission Fluid Level

Once you have added new transmission fluid, you need to reset the transmission fluid level. To do this, start the engine and let it idle for a few minutes. Then, put the car in drive and shift through all of the gears. Finally, put the car back in park and check the transmission fluid level on the dipstick. The fluid level should be at the “Full” mark.

Tips

• Use a hand pump that is specifically designed for pumping transmission fluid.
• Make sure the hand pump is inserted all the way to the bottom of the dipstick tube.
• Pump the transmission fluid slowly and steadily.
• Add new transmission fluid until the level reaches the “Full” mark on the dipstick.
• Check for leaks after adding new transmission fluid.
• Reset the transmission fluid level after adding new fluid.

Conclusion

Changing the transmission fluid in your car is a relatively simple task that can be completed in about 30 minutes. By following the steps outlined in this guide, you can easily pump the old transmission fluid out of your car and add new fluid.