Car Mechanic Simulator 2018 Transmission Gear Ratio

Introduction

Car Mechanic Simulator 2018 is a realistic car mechanic simulation game that allows players to repair and restore cars. One of the most important aspects of a car’s transmission is its gear ratio, which determines how much torque the engine produces at different speeds. In this guide, we’ll explain how to adjust the gear ratio in Car Mechanic Simulator 2018.

How to Adjust the Gear Ratio

To adjust the gear ratio in Car Mechanic Simulator 2018, you’ll need to first open the car’s transmission. To do this, follow these steps:

1. Lift the car onto a lift or jack stands.
2. Locate the transmission pan on the bottom of the car.
3. Remove the bolts that hold the transmission pan in place.
4. Carefully remove the transmission pan.

Once you have the transmission pan removed, you’ll need to locate the gear ratio adjustment bolt. This bolt is typically located on the side of the transmission case.

To adjust the gear ratio, use a wrench to turn the adjustment bolt. Turning the bolt clockwise will increase the gear ratio, while turning it counterclockwise will decrease the gear ratio.

Once you’ve adjusted the gear ratio to your desired setting, replace the transmission pan and tighten the bolts.

Tips for Adjusting the Gear Ratio

Here are a few tips for adjusting the gear ratio in Car Mechanic Simulator 2018:

* If you’re not sure what gear ratio to use, start by setting it to the factory default.
* If you’re planning on doing a lot of high-speed driving, you’ll want to use a higher gear ratio.
* If you’re planning on doing a lot of low-speed driving, you’ll want to use a lower gear ratio.
* If you’re not happy with the gear ratio you’ve set, you can always adjust it again.

Conclusion

Adjusting the gear ratio in Car Mechanic Simulator 2018 is a relatively simple process. By following the steps in this guide, you can easily adjust the gear ratio to your desired setting.