DIY Electric Car Automatic Transmission
Introduction
Electric cars are becoming increasingly popular, and for good reason. They’re more efficient than gasoline-powered cars, they produce zero emissions, and they’re often much cheaper to operate. However, one of the biggest drawbacks of electric cars is that they typically have only one gear. This can make them difficult to drive in stop-and-go traffic or on hills.
A solution to this problem is to install an automatic transmission in your electric car. This will allow the car to shift gears automatically, making it easier to drive in all conditions.
There are a few different ways to install an automatic transmission in an electric car. One option is to use a transmission from a gasoline-powered car. However, this can be difficult and expensive, as it requires modifying the car’s drivetrain.
A better option is to use a purpose-built electric car transmission. These transmissions are designed specifically for electric cars, and they are much easier to install.
In this article, we will walk you through the steps of installing an automatic transmission in an electric car. We will also provide a list of the parts you will need and the tools you will need.
Parts List
* Electric car transmission
* Transmission controller
* Wiring harness
* Mounting brackets
* Bolts and nuts
Tools List
* Socket wrench set
* Torque wrench
* Screwdriver set
* Wire strippers
* Crimping tool
Installation Instructions
1. Disconnect the battery. This is a very important safety precaution. Failure to disconnect the battery could result in serious injury or death.
2. Remove the existing transmission. This will vary depending on the make and model of your car. However, in general, you will need to remove the bolts that hold the transmission to the engine and to the driveshaft. Once the bolts are removed, you can carefully slide the transmission out of place.
3. Install the new transmission. This is the reverse of step 2. Carefully slide the new transmission into place and bolt it to the engine and to the driveshaft.
4. Install the transmission controller. The transmission controller is a small electronic device that controls the shifting of the gears. It is typically mounted on the transmission itself.
5. Connect the wiring harness. The wiring harness is a bundle of wires that connects the transmission controller to the battery, the motor, and the other electrical components in the car.
6. Mount the mounting brackets. The mounting brackets are used to secure the transmission to the car. They are typically bolted to the frame of the car.
7. Reconnect the battery. Once all of the components are installed, you can reconnect the battery.
8. Test the transmission. Once the battery is reconnected, you can test the transmission by driving the car.
Conclusion
Installing an automatic transmission in an electric car is a relatively simple process. By following the steps in this article, you can easily upgrade your car to make it more comfortable and easier to drive.
