Towing a Manual Transmission Car in Gear

Introduction

If you need to tow a manual transmission car, it’s important to know the proper procedure. Towing a manual transmission car in gear can damage the transmission, so it’s important to follow the steps below carefully.

Steps

1. Put the car in neutral. This will disconnect the transmission from the wheels, allowing the car to be towed without damaging the transmission.
2. Release the parking brake. This will allow the car to roll freely.
3. Hook up the tow bar or tow rope to the car. Make sure the tow bar or tow rope is properly attached to the car’s frame, not the bumper.
4. Start the towing vehicle. The towing vehicle should be in gear and moving slowly.
5. Slowly release the brake on the towed car. The towed car should start to roll behind the towing vehicle.
6. Drive the towing vehicle at a slow speed. The towed car should be towed at a speed of no more than 35 mph.
7. Be aware of your surroundings. Make sure there are no obstacles in the way of the towed car.
8. Stop the towing vehicle and the towed car as soon as possible. Once you reach your destination, stop the towing vehicle and put the towed car in park.

Tips

• If you’re towing a manual transmission car over a long distance, it’s a good idea to stop every few hours and check the transmission fluid level.
• Never tow a manual transmission car in gear for more than 50 miles.
• If you’re not comfortable towing a manual transmission car in gear, you can have it towed on a flatbed truck.

Conclusion

Towing a manual transmission car in gear can be a risky procedure, but it can be done safely if you follow the steps above carefully. By following these steps, you can avoid damaging your car’s transmission.